How to Recover SOP - DWL-6700AP
Requirements:
Firmware 4.4.0.1_B006 or later
Note: Recovery procedure only supports after v.4.4.0.1_B006
Download from site...
Step 1 – Press and hold reset button
Step 2 – Power on DWL-6700AP by connecting AP to the PoE on power injector
Step 3 – Wait for ALL LEDs to turn on (as below):
Once completed (as Step 3), release the reset button
Step 4 – Connect cable from LAN (on PoE Injector) to PC and configure the LAN card of the PC to:
IP: 192.168.0.x
Step 5 – Open a Web-browser and go to the recovery mode Web-UI (192.168.0.1)
Step 6 – Use the Web-UI to upload the firmware and wait approximately 60 seconds
Or open cmd.exe and enter:
ping 192.168.0.1 –t
If it doesn’t respond then it has completed the recovery and go to Step 7
Step 7 – Once the above is completed, configure the LAN card of PC to:
10.90.90.x
Step 8 – Open a web browser and enter:
10.90.90.91
Username: admin
Password: admin (default)
You should now have the DWL-6700AP recovered and ready to configure.
2 Други потребители намират това за полезно.
Беше ли това полезно за Вас?2 Други потребители намират това за полезно.
Благодарим Ви за обратната връзка.
Съжаляваме, че не успяхме да помогнем! Натиснете тук за повече Въпроси и отговори или за да отидете в секция Поддръжка.
Това също може да Ви помогне:
- How to Setup AP Mode Basic Configuration - DWL-6700AP Прочети отговорите
- How to configure the Mac address filtering - DWL-6700AP Прочети отговорите
- How to Setup WDS with VLAN – DWL-6700AP Прочети отговорите