How to Access Web UI when Managed Mode - DWC and DWS- Series
Step 1 – Set AP in Debug Mode
DWS-4026, DWS-3160, DWS-3024L:
Click “Enable Debug” and enter a password
DWC-1000 and DWC-2000:
Click “Enable Debug” - ON and enter a password, confirm then click “Save”
Step 2 – Connect to the IP of the AP via Telnet (Port 23)
Step 3 – Enter the following command:
DLINK-WLAN-AP# set web-server http-status up
Login:
Web-UI Access:
DWS-4026, DWS-3160, DWS-3024L:
Click “Enable Debug” and enter a password
DWC-1000 and DWC-2000:
Click “Enable Debug” - ON and enter a password, confirm then click “Save”
Step 2 – Connect to the IP of the AP via Telnet (Port 23)
Step 3 – Enter the following command:
DLINK-WLAN-AP# set web-server http-status up
Login:
Web-UI Access:
Ti potrebbero interessare anche questi:
- DWC 1000 Configure MAC Filter Authentication Leggi la risposta
- How to Upgrade Firmware for Access Points with DWC-1000? Leggi la risposta
- How to Add Access Point and Configuration of Profiles in the DWC-1000 – FW-4.4.x Leggi la risposta
- How to Create Multi-SSIDs and VLANs - FW.4.4.x Leggi la risposta
- Come creare captive portal su DWC-1000 - FW.4.4.x Leggi la risposta
- How to Upgrade Firmware for Access Points with DWC-1000 FW.4.4.x Leggi la risposta
- How to Setup Captive Portal - DWC-2000 Wireless Controller Leggi la risposta
- How to Upgrade AP Firmware via TFTP Server - DWC-2000 Leggi la risposta
- How to Setup Bandwidth Control on DWC for Wireless Clients Leggi la risposta
- How to Backup Configuration File - DWS-3024L and DWS-3024 Leggi la risposta
- Come configurare DWS-3160 con 2 SSID separati da un VLAN en el DWS-3160? Leggi la risposta