How do I change the LAN IP address of my camera?
Example:
-
You need to set up a static IP address for your camera.
-
Changing the IP address from the default can prevent IP conflicts with other devices on your network.
Note: If you change the LAN IP address of the camera, you will need to enter the new IP address into your web browser’s address bar in order to access the configuration utility.
Step 1: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.
Step 2: The default username is admin and the password field should be left blank. Click OK.
Step 3: Click on Setup on the top menu bar.
Step 4: Go to Network Setup and select Static IP Address
Step 5: Change the IPv4 Address using the field provided. The new address should be within the same subnet as the factory default address (ie: 192.168.0.XXX).
Step 6: Click the Save Settings button to save the new settings.
Ti potrebbero interessare anche questi:
- How do I access my mydlink camera remotely? Leggi la risposta
- What can I do when Active X fails to install during my mydlink camera setup? Leggi la risposta
- How do I configure motion detection on my camera? Leggi la risposta
- How do I configure the audio settings on my DCS-5020L? Leggi la risposta
- How do I enable a new camera in D-ViewCam? Leggi la risposta
- How do I manually upgrade the firmware on my camera? Leggi la risposta
- How do I mount my camera to a wall or ceiling? Leggi la risposta
- How do I reset my camera to factory default settings? Leggi la risposta
- How do I set an administrator (admin) password on my DCS-5020L? Leggi la risposta
- How do I set up and install my DCS-5020L? Leggi la risposta
- How do I set up motion detection and recording in D-ViewCam? Leggi la risposta
- How do I set up scheduled recording in D-ViewCam? Leggi la risposta
- How many types of motion detection are available on my IP camera? Leggi la risposta