What if I forget the Admin password for my camera?
(How do I reset my camera to factory default settings?)
Note: After a factory reset you will need to re-register the camera with mydlink. Do not unplug the power during this procedure.
Step 1: With the unit on, place a paper clip into the hole on the back on the unit labeled Reset.
Step 2: Use the paperclip to press the button inside the hole for 10 seconds and release.
Step 3: The unit will then reboot. Once the LED light on the front of the unit stops blinking, the unit is reset and all settings are restored to their defaults.
Ti potrebbero interessare anche questi:
- How do I change the LAN IP address of my camera? Leggi la risposta
- How do I configure motion detection on my camera? Leggi la risposta
- How do I configure the audio settings (speaker and microphone) on my DCS-2136L? Leggi la risposta
- How do I find the IP address of my DCS-2136L and access the web-based user interface? Leggi la risposta
- How do I manually upgrade the firmware on my camera? Leggi la risposta
- How do I mount my camera to the wall or ceiling? Leggi la risposta
- How do I set an administrator (admin) password on my DCS-2136L? Leggi la risposta
- How do I set up and install my DCS-2136L? Leggi la risposta