How do I reset my camera to factory default settings?
Example:
-
If you forget your camera’s password and have not registered with the mydlink cloud service, you can perform a reset to return all settings to the factory default.
-
If you can’t open the login web page or log in to the device.
-
If you change your network environment.
-
If you want to assign device to another mydlink account.
-
If you encounter a problem while registering the device to the mydlink service.
-
If the setup wizard can’t find the camera.
Note: After a factory reset you will need to re-register the camera with mydlink
Step 1: With the unit on, use a paper clip to press the reset button inside the hole on the back on the unit labeled Reset.
Step 2: Hold the button down for 10 seconds and release.
Note: Do not unplug the power during this procedure.
Step 3: The unit will then reboot. Once the power light stops blinking, the unit is reset and all settings are restored to their defaults.
Ceci peut également aider.
- How do I access my mydlink camera remotely? Lire la réponse
- How do I change the LAN IP address of my camera? Lire la réponse
- What can I do when Active X fails to install during my mydlink camera setup? Lire la réponse
- How do I configure motion detection on my camera? Lire la réponse
- How do I enable a new camera in D-ViewCam? Lire la réponse
- How do I manually upgrade the firmware on my camera? Lire la réponse
- How do I mount my camera to a wall or ceiling? Lire la réponse
- How do I set an administrator (admin) password on my DCS-5020L? Lire la réponse
- How do I set up and install my DCS-5020L? Lire la réponse
- How do I set up motion detection and recording in D-ViewCam? Lire la réponse
- How do I set up scheduled recording in D-ViewCam? Lire la réponse