How to Change the Time and Date Zone Via CLI - DXS-3600-Series
Step 1 – Connect to console port of DXS-3600-32 and configure PuTTy as follows:
Note: COM7 is used in our example, however it may be different on you PC/Laptop. (To check this, you will need to go to Device Manager)
Step 2 – Once configured, click on “Session” and enter a name in “Saved Sessions”. Click “Save” then “Load”
Click “Open”
Step 3 – Once loaded, hit the enter key and create a user
Switch>enable
Switch#configure terminal
Switch(config)#username admin password admin
Switch(config)#username admin privilege 15
Switch(config)#exit
Switch#copy running-config startup-config
Destination filename startup-config? [y/n]: y
Saving all configurations to NV-RAM.......... Done.
Switch#end
Step 4 – To set your switch clock to the correct time and date, enter the following:
Switch#clock set 18:23:00 24 jun 2015
Switch#show clock
Current Time Source : System Clock
Current Time : 18:23:07, 2015-06-24
Time Zone : UTC -01:00
Daylight Saving Time : Disabled
If your clock is not showing the correct “Time Zone” or and the time is not correct then follow these commands:
Switch(config)#show clock
Current Time Source : System Clock
Current Time : 18:28:18, 2015-06-24
Time Zone : UTC -01:00
Daylight Saving Time : Disabled
Switch(config)#clock timezone - 2 (use (+) or (-)
Switch(config)#show clock
Current Time Source : System Clock
Current Time : 17:28:39, 2015-06-24
Time Zone : UTC -02:00
Daylight Saving Time : Disabled
Switch(config)#
Step 5 – Save changes by using the following commands:
Switch#copy running-config startup-config
Destination filename startup-config? [y/n]: y
Saving all configurations to NV-RAM.......... Done.
5 Други потребители намират това за полезно.
Беше ли това полезно за Вас?5 Други потребители намират това за полезно.
Благодарим Ви за обратната връзка.
Съжаляваме, че не успяхме да помогнем! Натиснете тук за повече Въпроси и отговори или за да отидете в секция Поддръжка.