How do I change the LAN IP address of my camera?
Step 1: Open a web browser and enter the IP address of your camera in the address bar (default is 192.168.0.20). If you do not know the IP address of your camera, please refer to the section entitled “How do I find the IP address of my DCS-2330L and access the web-based user interface?” in this FAQ. Press Enter.
Step 2: The User Name for the administrator account is admin. Enter your administrator password in the Password field. If you have not changed this from the default, leave this field blank. Click OK.
![picture](/nl/nl/-/media/faqs/dcs/dcs_2330l/027.png)
Step 3: Click on Setup from the menu at the top of the page.
Step 4: Select Network Setup from the menu on the left hand side of the page, and select the Static IP Address radio button.
Step 5: Enter the desired IP address for the camera in the IP address field. The new address should be within the same subnet as the default IP address (192.168.0.xxx).
Step 6: Click the Save Settings button to save the new settings.
Dit kan ook interessant zijn:
- How do I access my mydlink camera remotely? Lees antwoord
- How do I configure motion detection on my camera? Lees antwoord
- How do I configure the audio settings (microphone) on my DCS-2330L? Lees antwoord
- How do I find the IP address of my DCS-2330L and access the web-based user interface? Lees antwoord
- How do I manually upgrade the firmware on my camera? Lees antwoord
- How do I mount my camera to the wall or ceiling? Lees antwoord
- How do I set an administrator (admin) password on my DCS-2330L? Lees antwoord
- How do I set up and install my DCS-2330L? Lees antwoord
- What if I forget the Admin password for my camera? Lees antwoord
- Which types of motion detection are available on my IP camera? Lees antwoord