What can I do when Active X fails to install during my mydlink camera setup?

Step 1: If you have any firewall software installed (Norton, McAfee, Kaspersky), try temporarily disabling them and running the wizard again.

Step 2: Ensure you are running the latest setup wizard. Please visit http://mydlink.com/support to download the latest version for your mydlink camera.

Step 3: Check your Internet Explorer settings. Ensure that the security level is set to Medium-high or Medium. (If set to High, temporarily lower until setup is complete)

•Open Internet Explorer

•Click Settings > Internet Options

•Click on the Security tab. Ensure your Security level is set to Medium-High. If it is now, drag the slider to the appropriate setting. Click OK to save your configuration.

Reload the configuration interface home page to run the ActiveX control.

Rank: 1.5

Ezek szintén segíthetnek:

  • How do I access my mydlink camera remotely? Válasz
  • How do I change the LAN IP address of my camera? Válasz
  • How do I configure Internet Explorer to allow ActiveX Controls? Válasz
  • How do I configure motion detection on my camera? Válasz
  • How do I configure the audio settings (audio out and microphone) on my DCS-6004L? Válasz
  • How do I find the IP address of my DCS-6004L and access the web-based user interface? Válasz
  • How do I manually upgrade the firmware on my camera? Válasz
  • How do I mount my camera to the wall or ceiling? Válasz
  • How do I set an administrator (admin) password on my DCS-6004L? Válasz
  • How do I set up and install my DCS-6004L? Válasz
  • What do I do if I forget the Admin password for my camera? Válasz