How do I find the IP address of my DCS-6004L and access the web-based user interface?

If your camera is connected to your router as a DHCP client, the IP address of your camera will change depending on the DHCP address assigned to it by your router. In order to access the web-based user interface, follow the below steps to determine the IP address of your camera.

Note: the following instructions are for Windows® 7.

Step 1: Open My Computer.

Step 2: From the menu on the left-hand side, click on Network.

picture

Step 3: Under the Media Devices section, locate the DCS-6004L and right-click on the icon. Select Properties from the pop-up menu.

picture

Step 4: In the Properties window, locate the IP address at the bottom of the window. This is the IP address of your camera. Make a note of this address.

picture

Step 5: Open a web browser, such as Internet Explorer, and enter the IP address of your camera in the address bar.

picture

Step 6: A pop up window will ask for the login credentials. The username for the administrator account is admin. Enter your administrator password in the password field. If you have not changed this from the default, leave this field blank. Click OK.

Rank: 1.5

Otros usuarios también consultaron:

  • How do I access my mydlink camera remotely? Ver respuesta
  • How do I change the LAN IP address of my camera? Ver respuesta
  • How do I configure Internet Explorer to allow ActiveX Controls? Ver respuesta
  • How do I configure motion detection on my camera? Ver respuesta
  • How do I manually upgrade the firmware on my camera? Ver respuesta
  • How do I mount my camera to the wall or ceiling? Ver respuesta
  • How do I set an administrator (admin) password on my DCS-6004L? Ver respuesta
  • How do I set up and install my DCS-6004L? Ver respuesta
  • What can I do when Active X fails to install during my mydlink camera setup? Ver respuesta
  • What do I do if I forget the Admin password for my camera? Ver respuesta