How do I open ports on my DFL Series Firewall?

Note: This FAQ will demonstrate how to set up port mapping for remote desktop to a computer running on the LAN port with a private IP address of 192.168.1.2, or 192.168.10.2 (depending on your firewall product).

Step 1: Open the web browser and type the IP address of the firewall into the address bar, and press Enter. Default IP address for the firewall is:

DFL-210/260/800/860/1600: 192.168.1.1
DFL-260E/860E/1660: 192.168.10.1

Step 2: Click on the plus sign next to Objects, select Address Book, and then select Interface Addresses.



Step 3: Click on Add and select IP address from the drop down menu.



Step 4: Configure the IP address as followed:

• Name: Name as desired (private_ip in this example).
• IP Address: IP address of the computer that is going to be mapped.

Click on OK.



Step 5: Click on the plus sign next to Rules and then select IP Rules.



Step 6: Click on Add and then select IP Rule Folder from the drop down menu.



Step 7: Enter a name as desired (port_mapping in this example) and then click on OK.



Step 8: Click on Add and select IP Rule from the drop down menu.



Step 9: Create the IP Rule as followed:

• Name: Name as desired
• Action: SAT
• Service: rdp
• Schedule: None
• Source interface: any
• Source network: all-nets
• Destination interface: core
• Destination network: wan1_ip

Note: If WAN1 is configured for DSL(PPPoE) or DHCP, select ip_wan1 as the Destination Network. If WAN1 is configured for Static, select wan1_ip as the Destination Network



Step 10: Click on the SAT tab and under New IP Address select private_ip (as created in Step 4) from the dropdown menu. Check the box labeled All-to-One mapping: rewrite all destination IPs to a single IP and then click on OK.



Step 11: Click on Add to create another IP Rule and configure it as followed:

• Name: Name as desired
• Action: Allow
• Service: rdp
• Schedule: None
• Source interface: any
• Source network: all-nets
• Destination interface: core
• Destination network: wan1_ip

Click on OK.



Step 12: Click on the Configuration tab and select Save and Activate from the dropdown menu. Click on OK to save and activate your changes.