How do I use the AP Grouping Settings on my DWL-2700AP?

Step 1 Open a web browser and type the IP address of the DWL-2700AP in the address bar (default is 192.168.0.50). Press Enter.

Step 2 The default username is admin (all lower case) and the default password is blank (nothing). Click OK.

Step 3 Click the Advanced tab and then click Grouping to the left.

Step 4 Next to Load Balance select Enabled using the drop-down list.



When you Enable Load Balance you allow several access points to balance wireless network traffic and wireless clients among the access points with the same SSID. All the APs that share Load Balancing must have the same SSID. Assign each Access Point a different non-overlapping channel (e.g., 1, 6, 11).

Step 5 Next to Link Integrate select Enabled using the drop-down list.



Note: When Link Integrate is Enabled, the wireless segment associated with the AP will be disconnected whenever the connection between the AP and the LAN is dropped.

Step 6 Click Apply and then click Continue to save the new settings.