How do I set up a mydlink-enabled Cloud Camera?

Please follow the below steps in order to set up your mydlink-enabled Cloud Camera:

Step 1: Connect one end of an Ethernet cable to the Ethernet port on your camera, then connect the other end of the cable to your local network via a router or switch, or directly to a computer for configuration.

Note: The computer used to access the camera's web-based configuration manager must be on the same subnet as the camera.


Step 2: Go to the mydlink support page and download the setup wizard specific to your device and operating system. If the setup wizard is a zip file, you will need to unzip it before running it.

Step 3: Follow the on-screen instructions to configure your Cloud Camera.

Rank: 1.5

Inne pomocne materiały:

  • Active X fails to install during my mydlink camera setup Przeczytaj
  • Error Unable to connect to mydlink website during Setup Wizard Przeczytaj
  • How do I add a mydlink-enabled device to my account if it's currently registered to another account? Przeczytaj
  • How to add 2nd camera to the same mydlink account? Przeczytaj
  • I'm using the Setup Wizard for my camera, but it won't let me save the camera's password. Przeczytaj
  • I'm getting error Cannot find Camera during my Mydlink camera setup Przeczytaj
  • I'm getting error Unable to add this device to your mydlink account during my mydlink camera setup Przeczytaj
  • What should I do if I can NOT set the device password Przeczytaj
  • What should I do if I forget my mydlink-enabled products device password Przeczytaj
  • What should I do if the setup wizard can't find my device? Przeczytaj