Cookies
Deze website maakt gebruik van cookies. Door deze website te gebruiken, gaat u akkoord met onze Cookie Policy. Lees meer
OK

Categorieën Veelgestelde vragen

Thank you for your feedback.

Sorry we couldn't help! Click here for more FAQs or go to Support.

How do I reset my DFL-200/DFL-700/DFL-1100 back to factory default settings?

Note: The DFL-1100 can only be reset using aconsole connection and via the web-based configuration.

You can perform a factory reset using any of the three methodslisted below:

  • Reset Button (DFL-200 & DFL-700 only)
  • Web Configuration (DFL-200, DFL-700 & DFL-1100)
  • Console Connection (DFL-200, DFL-700 & DFL-1100)

Reset Button

To perform a factory reset using the reset button, do thefollowing:

Step 1 Make sure that the DFL-200/DFL-700 ison.

Step 2 Press and hold the button located on theback of the DFL-200/DFL-700 below the word Reset using apaper clip for 10 seconds.

Web Configuration

To preform a factory reset using the web-based configuration, dothe following:

Step 1 Open a web browser and type the IP addressof the DFL-200/DFL-700/DFL-1100 in the address bar (default is192.168.1.1). Press Enter.

Step 2 The default username isadmin (all lower case) and there is no defaultpassword. Click OK.

Step 3 Click the Tools tab thenclick Reset to the left.


Step 4 Underneath the Restore to factorydefaults click on Restore to FactoryDefaults.

Note: On the next start up, the LAN IP addresswill be 192.168.1.1, and the web GUI will begin with the SetupWizard. The DFL-200/DFL-700/DFL-1100 will not accept connections onany interface other than the LAN interface.

Console Connection

To perform a factory reset using a console connection, do thefollowing:

Step 1 Connect one end of the supplied serialcable to the DFL-200/DFL-700/DFL-1100 and connect the other end toyour PC. If a serial cable did not come with yourDFL-200/DFL-700/DFL-1100 then contact Tech Support.

Step 2 Run HyperTerminal fromStart > Programs >Accessories > Communications> HyperTerminal.

Step 3 On the Connection Descriptionwindow, enter a name for this connection. ClickOK.

Step 4 On the Connect To window, selectthe COM port that the serial cable is connected to using thedrop-down box next to Connect Using. ClickOK.

Step 5 On the COMX Properties (Xrepresents the COM port number) window, select the followingsettings using the drop-down boxes:

  • Bits per second - 9600
  • Data bits - 8
  • Parity - None
  • Stop bits - 1
  • Flow control - Hardware

Click OK

You will now see a blank screen which shows Connected atthe bottom left hand corner of the screen.

Step 6 Power off for 5 seconds and then power onthe DFL-200/DFL-700/DFL-1100.

Step 7 You will now see the screen below. Pressany key on your keyboard to load the boot menu.

Step 8 At the Boot Menu screen select1. Reset unit to factory defaults by pressing1 on your keyboard. PressEnter.

Step 9 When prompted, press Ythen press Enter to reset theDFL-200/DFL-700/DFL-1100 back to factory defaults.

Vond u dit nuttig?
2 mensen vonden dit nuttig
Rank: 1.5