How do I set an administrator (admin) password on my DCS-942L?

Note: mydlink Cloud Service registration requires the admin password
Step 1: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.

Step 2: The default username is admin and the password field should be left blank. Click OK.

picture

Step 3: Click the Maintenance tab at the top and then click Admin from the menu on the left-hand side.

picture

Step 4: To change the administrator password, enter the existing administrator password (leave blank by default), and enter a new password in the Admin Password Setting section. You will need to type the new password again in the Confirm New Password field.

Step 5: Click Save to save the configuration.

Note: If you forget the administrator password, you will need to reset the device to the factory default in order to access the configuration utility

Rank: 1.5

These may also help:

  • What do I do if I forget the login username & password of my camera? Read Answer