Cookies
Unsere Webseite verwendet Cookies. Wenn Sie auf der Seite weitersurfen, stimmen Sie unserer Cookie-Richtlinie zu. Mehr erfahren
OK

Support

DES-6500 - Revision A

This product was phased out on:
01.04.2010
This product was phased out on:
01.04.2010

Datenblätter
Version Datum Typ Dateigröße
-
-
-
Handbücher
Version Beschreibung Datum Typ Dateigröße
-
Show moreShow less
-
-
-
Firmware
Do NOT upgrade firmware on any D-Link product over a wireless connection. Failure of the device may result. Use only hard-wired network connections.
Version Beschreibung Datum
Firmware
Show moreShow less
08.10.2010
Software
Version Beschreibung Datum
-
Show moreShow less
-
Weitere Downloads
Version Beschreibung Datum
-
Show moreShow less
-
Support
  • Fully Compliant with IEEE 802.3/802.3u/802.3ab/802.3z Standard
  • ANSI/IEEE 802.3 NWay auto-negotiation
  • MDI/MDI-X Auto-detection
  • IEEE 802.3x Flow Control in Full-duplex, Back Pressure in Half-duplex

DES-6500 Chassis System

  • Number of User-configurable Slots: 8
  • 2 Redundant Power Supply Bays
  • Backplane Switch Fabric Bandwidth: 160Gbps
  • Up to 96Gigabit Ethenet Ports
  • Up to 192 Fast Ethernet Ports
  • 3k IP Address, 16K MAC address, 4K VLAN (max.)
  • 8 Hardware Priority Queues
  • 32 Trunking Group, 8 port/Group
  • RAM Buffer: 128MB per Line Card, 256MB of CPU card

DES-6502 CPU/Fabric Switching Module (Shipped with DES-6500)
  • RS-232 Console Port (DB9) : DCE, 115200, N, 8, 1
  • Reset, Alarm Off Buttons
  • System, Power LED
  • 160 Gbps Switching Capacity
  • Up to 142 Mpps Forwarding Rate Support
  • 256MB SDRAM
  • 512KB for Boot code and 16 MB for Runtime code

DES-6504 12 port 100BASE-FX MMF LC Module

  • Fully compliant with IEEE 802.3u 100BASE-FX
  • IEEE 802.3x compliant Flow Control support for Full-duplex
  • Supports (SFF) LC type connections
  • Cable distances up to 2km in full duplex on Multi-Mode Fiber

DES-6506 24-port RJ-21 to RJ-45 Patch Panel

  • Patch panel support 2 RJ-21 ports to 24-port RJ-45 10/100 BASE-TX Interface
  • Compatible with the DES-6510 RJ-21 Telco Module
  • Use in conjunction with DES-6510 module
  • Supports 2 RJ-21/Telco 50 connectors
  • 1U high

DES-6507 12-port 10/100/1000Base-T + 2SFP Combo Module
  • Fully Compliant with IEEE 802.3/802.3u/802.3ab/802.3z Standard
  • ANSI/IEEE 802.3 NWay auto-negotiation
  • MDI/MDI-X Auto-detection
  • IEEE 802.3x Flow Control in Full-duplex
  • 10BASE-T Copper Cable:
  • 2-pair UTP CAT 3,4, 5 (100m max)
  • EIA/TIA-568 100-ohm STP (100m max.)
  • 100BASE-TX/1000BASE-T Copper Cable:
  • 2-pair or 4 pair UTP CAT 5 or Better (100m max.)
  • EIA/TIA-568 100-ohm STP (100m max.)
  • Fiber Cables: 50, 62.5/125 Micron Multimode Fiber, 9 Micron Singlemode Fiber
  • LED report (per port): Link/Act

DES-6508 16-port 10BASE-T/100BASE-TX RJ-45 Fast Ethernet Switch module

  • Fully compliant with IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX
  • All 10/100Mbps ports support auto-negotiation
  • Back pressure Flow Control support for Half-duplex mode
  • IEEE 802.3x compliant Flow Control support for Full-duplex

DES-6509 12-port 1000Base-X SFP Fiber Module

  • Fully Compliant with IEEE 802.3z Standard
  • IEEE 802.3x Flow Control in Full-duplex
  • Fiber Cables: 50, 62.5/125 Micron Multimode Fiber, 9 Micron Singlemode Fiber
  • LED report (per port): Link/Act

DES-6510 24 Port 10/100Mbps RJ-21 Telco 50 Module
  • 2 RJ-21, each support 12-port 10BASE-T/100BASE-TX ports
  • Fully compliant with IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX
  • All 10/100Mbps ports support auto-negotiation
  • Back pressure Flow Control support for Half-duplex mode
  • IEEE 802.3x compliant Flow Control support for Full-duplex

DES-6511 Power Supply
  • Full Redundant Feature Design
  • Hot-swappable Power Source
  • Power Management Function Enabled
  • 2 Fans Included
  • Removable Handle Design
  • Input: 90 ~ 264 VAC, 47 ~ 63 Hz
  • Output: 3.3V:4A ~ 80 A; 12V: 0.1A ~2A

DES-6512 2 Port 10G XFP module for DES-6500 chassis
  • IEEE 802.3ae compliance
  • Support Full-Duplex operation only
  • Support XFP MSA compliant transceivers
  • 256MB SDRAM
  • Flash: 512KB for boot code, 16MB for runtime code
  • LED indicators

Network Cable
  • 10Base-T:
    • 2-pair UTP CAT 3,4, 5
    • EIA/TIA-568 100-ohm STP
  • 100Base-TX/1000Base-T:
    • 2-pair or 4 pair UTP CAT 5 or Better
    • EIA/TIA-568 100-ohm STP
  • 1000Base-SX:
    • 50, 62.5/125 Micron Multimode Fiber
  • 1000Base-LX:
    • 50, 62.5/125 Micron Multimode Fiber
    • 9 Micron Singlemode Fiber