How do I enable WEP encryption on the DWL-520 / DWL-650?
It is recommended to enable encryption on your wireless routeror access point before your wireless network adapters. Pleaseestablish wireless connectivity before enabling encryption.
Note: Your network will slow down and wirelesssignal may degrade when enabling encryption due to the addedoverhead.
Site Survey
Step 1 Double-click the bar graph icon in thesystem tray (the area in the lower right-hand corner of the screen,by the clock) and select Site Survey.
Step 2 Select your SSID in the AvailableNetworks Authentication section for the auth. mode. ClickConnect.
Step 3 Enable encryption and configure thesettings below Auth. mode. to match those configured onyour access point or wireless router.
Step 4 Click OK.
Windows XP SP1 (or no service pack)
Step 1 Right-click the two computer monitors iconin the system tray (the area in the lower right-hand corner of thescreen, by the clock) and select View Available WirelessNetworks.
Step 2 Click Advanced.
Step 3 Uncheck Use Windows to configure mywireless network settings and clickOK.
Step 4 Double-click the bar graph icon in thesystem tray (the area in the lower right-hand corner of the screen,by the clock) and select Site Survey.
Step 5 Select your SSID in the AvailableNetworks Authentication section for the auth. mode. ClickConnect.
Step 6 Enable encryption and configure thesettings below Auth. mode. to match those configured onyour access point or wireless router.
Step 7 Click OK.
Windows XP SP2
Step 1 Right-click the wireless icon in the systemtray (the area in the lower right-hand corner of the screen, by theclock) and select View Available WirelessNetworks.
Step 2 In the Wireless NetworkConnection window click Change advancedsettings on the right side below RelatedTasks.
Step 3 Uncheck Use Windows to configure mywireless network settings and then clickOK.
Step 4 Double-click the bar graph icon in thesystem tray (the area in the lower right-hand corner of the screen,by the clock) and select Site Survey.
Step 5 Select your SSID in the AvailableNetworks Authentication section for the auth. mode. ClickConnect.
Step 6 Enable encryption and configure thesettings below Auth. mode. to match those configured onyour access point or wireless router.
Step 7 Click OK.
If your wireless network is not showing in SiteSurvey
Step 1 Double-click the bar graph icon in thesystem tray (the area in the lower right-hand corner of the screen,by the clock) and select Encryption.
Step 2 Select Data Encryption andthen select Shared Authentication next toAuth. mode. Select 64,128, or 256-bit encryption forthe key length. Next to Key 1 type in the Hex encryptionkey that was entered into the wireless router/access point.
Step 3 Click Apply to save yoursettings.
3 Други потребители намират това за полезно.
Беше ли това полезно за Вас?3 Други потребители намират това за полезно.
Благодарим Ви за обратната връзка.
Съжаляваме, че не успяхме да помогнем! Натиснете тук за повече Въпроси и отговори или за да отидете в секция Поддръжка.